Deepest Cubic Burning Ship

[Kalles Fraktaler]

Cubic Burning Ship reaching exponent 1000.
Kalles Fraktaler is an environment friendly application. Because the key frames were rendered on a 7-year old dual core 32-bit laptop, in 11 days. Old hardware can still be used to create magic!

<a href="http://www.youtube.com/v/EFTmpL0ahHY&rel=1&fs=1&hd=1" target="_blank">http://www.youtube.com/v/EFTmpL0ahHY&rel=1&fs=1&hd=1</a>

Also here is a test of skewing Burning Ship spirals:

<a href="http://www.youtube.com/v/JOQPkTeQr9o&rel=1&fs=1&hd=1" target="_blank">http://www.youtube.com/v/JOQPkTeQr9o&rel=1&fs=1&hd=1</a>

[Kalles Fraktaler]

The path of this very deep cubic burning ship zoom was mainly selected automatically.
I zoomed manually to about e30. Then I turned the "non-exact find minibrot" on, which basically zooms randomly. When using the short key ctrl+M to find the minibrot, a popup is displayed where the final exponent value can be entered. I set it to 670.
When it was finished I center the zoom manually a few clicks, turned off the non-exact function and selected the find minibrot again. And it found the minibrot just a little deeper than e1000.
Zoom size 32 was used during this process.

So I let my old laptop do the hard work while I was doing other things

[TheRedshiftRider]

Im trying this with a slightly deeper zoom into the mandelbrot. I have the reuse-reference on. And it zooms out and in but does not change in depth, should it be doing this? Should I turn the reuse off?

Edit: Found it, I have to learn to take time to read things. 

[Kalles Fraktaler]

I don't know how you could make it zoom in and out, but it is good that you found a solution to it

Re-usage of reference should only be done close to a really deep minibrot, or when zooming deep into a needle, i.e. without any visible embedded julia sets.

[TheRedshiftRider]

I had the reuse on but thats for zooming out. When there are no other calculated references the program automatically zooms out. I just had to turn off the reuse. Though that will make everything slow down. I used the reuse for zooming automatically and it worked for about 1000 exponents.

[PieMan597]

I don't know how you could make it zoom in and out, but it is good that you found a solution to it

Re-usage of reference should only be done close to a really deep minibrot, or when zooming deep into a needle, i.e. without any visible embedded julia sets.

I usually have the reuse reference on while zooming out. Even if some areas are glitches, my computer still has to do about a thousand less references. Then I just use the glitch finder, and I get an hour or two shaved off my render time.